30
2024-03-30
Results Brief | Maneuverability Study of the Paddle–Rudder Integrated “Black Pearl” Unmanned Surface Vehicle
Summary:
I. Introduction
The Unmanned Surface Vehicle is a novel ocean mobile observation platform powered by wave energy and solar energy. It offers advantages such as long endurance, wide-area coverage, and low operational cost, and is widely applied in ocean observation, marine resource exploration, and defense security. However, due to uncertainties in the marine environment, energy limitations, and the lack of effective control strategies, existing Unmanned Surface Vehicles still do not achieve full autonomy.
The paddle–rudder integrated Unmanned Surface Vehicle independently developed by HydrovoX addresses these limitations by combining a rudder system with a vector thruster, thereby significantly enhancing the maneuverability of the platform. Maneuverability is a key performance indicator for evaluating the overall capability of the paddle–rudder integrated Unmanned Surface Vehicle. Good maneuverability is essential for autonomous navigation, station-keeping, and obstacle avoidance tasks.
II. Overview of the Study
The maneuverability of the paddle–rudder integrated Unmanned Surface Vehicle is analyzed from two aspects: speed regulation and turning performance. Numerical simulations of forward speed performance are conducted under four different marine environmental conditions. The rudder angle is set to 0°, and the forward velocity curves of the system under four different propeller rotational speeds are shown in Figure 1.

(a) #a

(b) #b

(c) #c

(d) #d
Figure 1. Forward velocity performance curves of the paddle–rudder integrated Unmanned Surface Vehicle under different environmental conditions.
Under marine environmental conditions #a and #b, a turning maneuver simulation was conducted. The turning performance of the Unmanned Surface Vehicle was compared under rudder angles of 10°, 20°, and 30°, both with the propeller turned off and with the propeller operating at 240 rpm. The simulated turning trajectories of the Unmanned Surface Vehicle are shown in Figure 2 and Figure 3.

Figure 2. Turning trajectories of the Unmanned Surface Vehicle under different rudder angles in environmental condition #a.

Figure 3. Turning trajectories of the Unmanned Surface Vehicle under different rudder angles in environmental condition #b.
The simulation results indicate that under four different sea states, as the propeller rotational speed increases within a certain range, the average forward velocity of the Unmanned Surface Vehicle increases significantly. The propeller provides additional thrust to the system, thereby reducing the Unmanned Surface Vehicle’s dependence on wave conditions and enabling operation at a certain speed even in low sea states and nearshore environments, with improved current resistance capability. Compared with sea state III conditions, the performance improvement in forward speed is more pronounced under sea state II when the propeller is activated.
The turning performance simulations further show that under low sea state conditions, activating the propeller significantly enhances the turning capability of the Unmanned Surface Vehicle, resulting in a noticeable reduction in turning radius.
III. Sea Trial Experiment
To validate the reliability of the maneuverability analysis of the paddle–rudder integrated Unmanned Surface Vehicle, sea trials were conducted in the nearshore waters of Qingdao. The Unmanned Surface Vehicle used in the experiments was equipped with sensors such as GPS, wave sensors, and a compass for data acquisition.
Figure 4 shows the propeller performance test trajectory, which was used to evaluate the forward speed at a propeller rotation rate of 180 rpm with a rudder angle of 0°, as well as the turning performance at 240 rpm with a rudder angle of 10°.

Figure 4. Propeller test trajectory during the sea trial.
Figure 5. Trajectories of the paddle–rudder integrated Unmanned Surface Vehicle under fixed rudder angles of 10°, 20°, and 30°.

Figure 5. Turning maneuver test trajectories during the sea trial.
Figure 6. Comparison between simulated and sea-trial results of the turning motion of the paddle–rudder integrated Unmanned Surface Vehicle under rudder angles of 10°, 20°, and 30°.

Figure 6. Comparison of simulated and sea-trial results for the turning performance of the WG (Unmanned Surface Vehicle).
Before the propeller was activated, the average speed of the paddle–rudder integrated Unmanned Surface Vehicle was approximately 0.408 m/s. After activation, the average speed increased to about 0.597 m/s, indicating that the integrated paddle–rudder system can significantly enhance the forward velocity of the Unmanned Surface Vehicle to a certain extent.
When the propeller is operating, the turning radius is significantly reduced, and the maneuverability of the Unmanned Surface Vehicle is markedly improved. With increasing rudder angle, the turning radius decreases notably, which is consistent with the simulation trends. In addition, by comparing the sea trial and simulation results, the error range is observed to be within 5%–10%, indicating good agreement between numerical and experimental results and demonstrating the reliability of the maneuverability analysis.
IV. Conclusions and Outlook
This study investigates the maneuverability of a new-generation “Black Pearl” paddle–rudder integrated Unmanned Surface Vehicle. The maneuverability is analyzed from both speed regulation and turning performance perspectives through numerical simulations. The results show that the integrated system exhibits excellent forward speed performance and strong turning capability.
Under different sea states, when the propeller speed reaches 300 rpm, the maximum average forward velocity of the Unmanned Surface Vehicle can increase by up to 3.5 times. Compared with the case without propeller activation, the average turning diameter at 240 rpm is reduced by approximately 2.52 times.
By comparing sea trial results with simulation data, the reliability of the numerical maneuverability analysis is validated, providing a solid theoretical foundation for the application of paddle–rudder integrated Unmanned Surface Vehicles in complex and diverse marine environments.
(Source: Ocean Engineering, 2024, Vol. 294. References omitted. Copyright belongs to the publisher and authors. This content is reproduced for academic learning and exchange with authorization.)
Key words:
Related News
How GNSS Positioning Solutions are Transforming Marine Surveying Techniques
How GNSS Positioning Solutions are Transforming Marine Surveying Techniques In the rapidly evolving field of marine surveying, the integration of GNSS (Global Navigation Satellite System) positioning solutions has revolutionized traditional methods of data collection and analysis. This article delves into how GNSS technology enhances precision, reliability, and safety in marine surveying, paving t
Nov 15,2026
Enhancing Deep Sea Navigation: The Role of Underwater Beacons in Positioning
The advent of underwater beacons has significantly revolutionized deep-sea positioning, a critical aspect of various marine operations, including scientific research, underwater construction, and search-and-rescue missions. These devices, often deployed to assist in locating submersible vehicles or underwater assets, utilize acoustic signals to provide real-time positioning data, which is vital fo
Nov 10,2026
A Comprehensive Guide to Selecting the Right Hydrophone Buoy for Marine Applications
A Comprehensive Guide to Selecting the Right Hydrophone Buoy for Marine Applications Table of Contents 1. Introduction to Hydrophone Buoys 2. What is a Hydrophone Buoy? 3. Importance of Hydrophone Buoys in Marine Research 4. Types of Hydrophone Buoys 5. Key Features to Consider When Selecting a Hydrophone Buoy 6. Environmental Factors Impacting Hydrophone Performance 7
Oct 21,2026
Understanding Shallow Water AIS Beacons: Enhancing Marine Safety and Navigation
Shallow water AIS beacons are specialized devices designed to aid navigation in shallow or restricted waters. AIS stands for Automatic Identification System, a vital communication tool for maritime safety that enables vessels to exchange information about their position, course, and speed in real time. These beacons serve as an important navigational aid, especially in areas where traditional navi
Oct 16,2026
Essential Marine AIS Beacon Transponder Maintenance Tips for Longevity
Essential Marine AIS Beacon Transponder Maintenance Tips for Longevity Table of Contents Understanding Marine AIS Beacon Transponders Importance of Regular Maintenance Routine Inspection Procedures Cleaning Your AIS Transponder Battery Maintenance and Replacement Software Updates and Firmware Management Troubleshooting Common Issues Professional Servicing: When to
Oct 11,2026
The Future of Wind Powered Unmanned Vessels: Revolutionizing Maritime Operations
In recent years, wind powered unmanned vessels have gained significant attention as a sustainable alternative in maritime operations. These vessels utilize wind energy as their primary propulsion source, which not only reduces reliance on fossil fuels but also minimizes greenhouse gas emissions. This environmentally conscious approach aligns perfectly with the global push for greener technologies
Oct 06,2026